Click for large photo

Product Description
Hygia Splint(Roll type) is intended for use in the construction of common orthopedic splints and consists of multiple layers of a knitted polyester fabric, impregnated with polyurethane resin. It is covered on both sides by air and moisture permeable non-woven fabric, which serves as padding.

Product Feature
Excellent molding capability
Light
Porous
Burnable after use
Environment-friendly
Cost-effective
Strong and rigid
Simple and easy to apply

Product Specification/Models
WS1051 450cm X 5cm (2" x 5yds)
WS1052 450cm X 7.5cm (3" x 5yds)
WS1053 450cm X 10cm (4" x 5yds)
WS1054 450cm X 12.5cm (5" x 5yds)
WS1055 450cm X 15cm (6" x 5yds)

Application
1. Select the desired size and pull out the splint from the box. Cut off the length you want by a bandage scissors and seal off the foil pouch with the provided sealing clip inside box to prevent air or moisture from coming inside the product. Make sure the foil is double folded for enforced sealing.
2. Immerse the splint in room temperature water, squeezing very hard once or twice while submerged. Squeeze excess water and try to wipe off with a dry towel to remove water on the splint. Warmer water will shorten the hardening time, while cooler water will prolong it.
3. Wrap with an elastic bandage. The splint can be folded back to determine the exact dimensions. Molding and forming should be done at this time. In areas of critical molding, keep your hands in place for 30 seconds to speed hardening. Set time is approximately 4~5 minutes. The splint will continue to gain strength for the first 25 minutes.